Field Controls 46491600 Motor
Quantity
-
Detail
Field Controls GMA-PL Motor GVD Damper
- Plastic Base
- Minimum Wiring Requirements 24 VAC, 18 Gauge, 105C
- Thermostat Heat Anticipation Add an additional 0.1 Amp to the specified or measured control circuit amps
- Power Draw Requirement 3W at 24 VAC when opening or closing
- Timing
- 15 sec, Power open
- 15 sec, Power close
This Field Controls replacement Motor with plastic base takes only a few minutes to install. It allows you to replace a defective motor without replacing an entire unit. This will save half the cost of replacing the entire assembly.
-
Customer ReviewsNo comments